Troubleshooting - AXENT .ELI Bedienungsanleitung

MAINTENANCE AND CLEANING
The used active carbon filter can be disposed in the normal household waste.
REPLACING THE BATTERIES OF THE REMOTE CONTROL
If the remote control cannot be activated or the LEDs blink on « r ear » and « L ady Wash » the batteries need do to be changed (2 x size
AAA/ type 1.5V).
Slide the flap open in direction of the arrow, which is on the back of the remote control. Remove the batteries and place the new ones
inside. Ensure correct polarity. Then close the flap.
PLEASE DISPOSE THE USED BATTERIES PROPERLY AND NOT INTO THE NORMAL WASTE BASKET.
REPLACING THE ACTIVE CARBON FILTER
Replace the active carbon filter approx. Every 6 months. The filter is
located beneath the toilet seat. We recommend you change the device
with help of another person.
Pull the main plug and press the release button (mounting panel) and then
pull the toilet seat forward. Place it horizontally on the floor or platform
without tilting it.
The water outlet does not need to be disconnected.
THE TOILET SEAT IS NOT ALLOWED TO BE TILTED. IT MUST
ALWAYS BE PLACED HORIZONTALLY.
WHILE ONE PERSON IS HOLDING THE TOILET SEAT HORIZONTALLY
THE OTHER CAN OPEN THE FLAP AND REPLACE THE AXENT
ACTIVE CARBON FILTER.
CLOSE THE FLAP AND SLIDE THE TOILET SEAT HORIZONTALLY
ON TO THE MOUNTING PANEL UNTIL IT CLICKS INTO PLACE.
24

TROUBLESHOOTING

ELECTRICAL SHOCK ! FATAL DANGER !
Never open the unit in order to repair it yourself. Never modify the device or add an any additional modules.
The AXENT shower toilet carries live parts and opening it exposes those present to fatal danger !
Warrantly and liability claims as a result of wrong handling are specifically exluded.
RESET
Perform a reset, if needed. Unplug the Axent toilet bidet an wait for 30 secondes, then reconnect the toilet with the main plug.
MALFUNCTION CAUSE
No Function Main plug ist not
connected
Vacation mode is
active.
Interrupted
power supply
Remote control does Batteries are dead
not work
Batteries are
not installed
Batteries are
inserted
incorrectly
Remote control
out of order
LEDs are blinking on Batteries are dead in
« Rear » und the remote control
« L ady Wash »
REMEDY
Plug in the main plug.
Press « S top » on the control panel
for 3 seconds
Stop
Check the power supply by a qualified
electrician.
Change the batteries as mentioned.
Stay in range of 2m to your toilet unit.
Place the batteries in your remote control as
mentioned. Stay in range of 2m to your toilet unit.
Check the batteries in your remote control and ensure
correct polarity. Stay in range of 2m to your toilet unit.
Please contact customer service.
Change the batteries in your remote control.
Stay in range of 2m to your toilet unit.
25
PAGE
21
24
24
24
24