Assembling The Bbq - tepro KEY WEST Bedienungsanleitung

t

Assembling the BBQ

1. unpack BBQ
Unpack the BBQ and dispose of
all packaging materials. Keep the
packaging materials out of the reach of
children and dispose of them according
to regulations after BBQ assembly.
Pay attention to the illustration of the
BBQ during assembly.
2. Fasten the handles to the fire bowl
Fasten the handles (1b) to the fire
bowl (8) with spacers (D) and nuts (F).
Ensure that
bevelled ends.
3. Fasten the long support legs
First, insert the small side of the support
leg caps (9) through the narrow ends
of the long support legs (11a). Insert
two M6x30 screws (C) with a spacer
(D) through the holes on the right side
of the handle of the fire bowl (8). Turn
the long support legs (11a) with the
support leg caps (9) loosely on the
screws. Turn the long support legs
so that the holes for the storage grille
(12) point inwards. Do not tighten the
screws yet.
4. Fasten the short support legs
First, insert the small side of the
support leg caps (9) through the narrow
ends of the short support legs (11b).
Insert two M6x30 screws (C) with a
spacer (D) through the holes on the
left side of the handle of the fire bowl
(8). Turn the long support legs (11a)
with the support leg caps (9) loosely
on the screws. Turn the short support
legs (11b) so that the flat bottom sides
with the holes for the storage grille
(12) point inwards. Do not tighten the
screws yet.
18
both handles have
5. Fasten the storage grille and wheels
First, insert the storage grille (12) into
the holes on the round ends of the long
support legs (11a). Then, insert the
other ends of the storage grille into the
holes of the short support legs (11b).
Attach the wheels (5) on both sides
and fasten with M8 nuts (e).
6. Fasten the ash collecting tray
Align the holes of the ash collecting
tray (10) over the support legs. Turn
the ash collecting tray so that it locks
in place. Now, tighten the screws of the
support legs.
7. Fasten the handle on the lid
Fasten the handle (1a) outside and the
lid hook (4) inside the lid with spacers
(D) and M6 nuts (F). Ensure that the
handle has straight ends.
8. Install the ventilation disc
Fasten the ventilation disc (2) to the
lid (3) with an M5x10 screw (A) and an
M5 nut (B).
9. Insert the charcoal grate and attach
the BBQ grate
Place the charcoal grate (7) in the
middle of the fire bowl (8). Place the
BBQ grate (6) on the fire bowl.
10. The BBQ has been completely
assembled.
Disassemble the
reverse order.
Important: All screws must be tightly
fastened.
BBQ in the