Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention: Do not connect this model
to other loco models with different
starting characteristics. This can
damage the internal gearing.
Analog version:
The model is equipped with a digital
interface to connect a 3 amp DCC
decoder (Fig. 6). Remove the plug on
the decoder interface and connect
the decoder.
Adding sound:
To equip these models with sound,
we recommend the following prod-
ucts:
- 65004 European Electric Loco
Sound Unit
- 65011 Sound Unit Power Storage
On the main circuit board of the rail-
car, there are two pins between the
two motor plugs. These pins can be
used to connect the 65004 Sound
Unit. The 65011 is not needed when
operating with the LGB Multi-Train
System.
If there is not enough space inside
the railcar or if you prefer not to dis-
assemble the model, you can place
the Sound Unit in a freight or pas-
senger car and connect it to the rail-
car via the multi-purpose socket.
Lighting
This model features directional light-
ing: Three white front lights and one
white rear light. Transparent red
stickers are included with the model
to obtain a prototypical red rear light
when running without a train.
The model has a "flat" multi-purpose
socket, with a removable cover, on
each end wall (Fig. 4). These sockets
can be used to provide track power
to LGB cars with lighting or sound
electronics.
To remove the cover of a socket, pull
it straight out. If the cover is tight,
gently use a small straight screw-
driver to pry it out. (Do not pull out
the rectangular outer housing.)
Power Supply
Attention! For safety and reliability,
operate this model with LGB power
supplies units (transformers, power
packs and controls) only. The use of
non-LGB power supplies will void
your warranty.
Use this model only with switched
mode LGB power supply and trans-
formers with an output of more than
1 amp.
Catenary Power Operation
This railcar can be operated with a
powered catenary system (see Oper-
ating Modes). The bottom of this
model is marked with a red dot.
Place the model on the track with the
red dot pointing to the rail that is not
connected to the catenary power
supply (Fig. 5).
Hint: To operate multiple trains on
the same track, we recommend the
LGB Multi-Train System (see Multi-
Train System). With the Multi-Train
System, you can use an unpowered
catenary system for prototypical
appearance.
CAUTION! This model may be pow-
ered with a catenary on analog lay-
outs only. For operation with the dig-
ital Multi-Train System, the model
must use track power. Otherwise,
dangerously high voltages may result.
Attention! After extended operation,
this model may leave carbon dust or
other debris around the track. This
dust and debris can stain carpet and
other materials. Consider this when
setting up your layout. LGB are not
liable for any damages.
9
Werbung
