Crimping Procedure - Rennsteig DigiCrimp0,14 – 6,0 mm Bedienungsanleitung

Operating Instructions
Four-indent crimping tool DigiCrimp® with digital display and wear monitoring
Standard mm
Setting the crimping parameters
· Refer to the adjustment matrix for die settings and contact bushing positions (3) for the
contact you intend to crimp.
· Change the crimping die setting (crimping die depth) by turning the adjustment wheel
until the digital display shows the desired value.
· Lock the crimper setting using the locking screw (2).
· Lift and turn the contact bushing (3) to the side (see Figure 2) into the setting shown on
the adjustment matrix.
Figure 2
NOTE
Always set the crimper depth from a larger value, such as from 2.05 mm to 2 mm.

3 Crimping procedure

· Feed the prepared cable into the connector.
· Lay the contact with the cable into the crimper's crimping point until it will not go
any further; the contact bushing will position the contact exactly.
· Close the crimper until unlocking via the catch.
· Open the crimper and remove the crimped contact.
Rev.: 2013-12-02
Inch
Type CR 2025 battery compartment
Clamping screw
for locking the crimper setting
MIL selector
positions
EN
5 / 10