Abus Smartvest Bedienungsanleitung Seite 75

FUHA35000 power switch


Schuko socket

Status LED

Button

Schuko socket
Repeater mode
As well as switching consumers, the power switch can also be used as a wireless repeater for another
component. To do this, take the following steps:
1. Press and hold the button for five seconds to activate repeater mode. The status LED starts to
flash orange.
2. For any components that you want to connect to the power switch, carry out the manual process
for pairing components (see chapter 5, Configuration).
3. The status LED lights up orange when the connection is successful
4. To deactivate repeater mode again, first disconnect the switch. Press and hold the button.
Reconnect the switch. Wait until the LED flashes blue and only then release the button. If
deactivation was successful, the LED will now light up blue.
Note
It is only ever possible to connect one component to a power switch.


Schuko socket type F (CEE 7/4). Can be used in the following countries:
Germany, Austria, Sweden, Netherlands
Off
On
Blue
Flashing
Flashing
Orange
On
Press this button once to activate or deactivate the power switch.
To do so, press and hold the button for five seconds, to activate repeater
mode.
Schuko socket type F (CEE 7/4). Can be used in the following countries:
Germany, Austria, Sweden, Netherlands

Power switch is activated; power is being
transmitted.
Power switch is ready and activated; power is not
being transmitted to the consumer.
Power switch is starting up
Repeater mode started
Power switch is ready and activated; power is not
being transmitted to the consumer.
Repeater mode on and connected with a
component.
11
English