Clatronic AE 3666 Bedienungsanleitung Seite 33

Stop Operation And Disassembly
1. Set the speed control (10) to "0" position and wait until the
filter / blade (4) has come to a complete standstill.
2. Disconnect from mains power supply.
3. Press the spout (6) upwards to prevent subsequent
dripping.
4. Remove the pusher (1) from the chute (2).
5. Take the juice jug to the side and lower the locking bar (8)
into the disengaged position.
6. Remove the lid (3).
7. Remove the pulp collector (11).
8. Remove the filter / blade unit (4) from the base (9) by
grasping the filter / blade (4) at its upper edge with two
hands.
WARNING risk of cuts!
The filter / blade unit (4) has sharp knives!
Only lift it on its outer edge.
9. Then pull the filter / blade (4) in an upward direction until
the filter / blade unit (4) is separated from the main base (9).
NOTE:
Do not remove screws from the blade (4). The filter and
the blade (4) are one piece. They are not meant to be
separated.
Cleaning
WARNING:
• Before cleaning always disconnect from mains power
supply.
• Under no circumstances should you immerse the appli-
ance in water for cleaning purposes. Otherwise this might
result in an electric shock or fire.
• The filter / blade (4) is very sharp! Danger of injury!
Malfunction Possible cause
The appliance The appliance is not supplied with
does not power.
function.
The locking bar (8) has not been closed. Check if all components were properly attached.
The appliance is defective.
The juice quanti- Wrong fruit type.
ty is small.
Too much residue in the filter / blade (4). Clean the filter / blade (4).
Loud noise and Bad assembly.
imbalance during
Too much residue in the filter / blade (4). When processing larger quantities clean the filter / blade (4)
operation.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Do not leave the pulp to dry on the filter / blade (4). The
fine pores will clog and become useless.
Tip
• Remove residues in the filter /
blade (4) immediately under
running water. Use a dishwash-
ing brush.
• For cleaning the outside of the
appliance, use only a damp
washing-up cloth.
Pusher (1), Lid (3), Filter / blade (4), Receptacle (5), Pulp
collector (11)
WARNING in regard to risk of cuts!
The filter / blade (4) is sharp!
CAUTION:
The attachments are not suitable for dishwasher. Heat
and aggressive cleaning agents may warp or discolour the
attachments.
• Clean these components in a rinsing bath.
• Clean the filter / blade (4) with a dishwashing brush.
• Rinse with clean water.
• Only assemble the appliance when all parts have been dried.
• Clean the appliance as described. Let the accessories dry
completely.
• We recommend that you store the appliance in its original
packaging when it is not to be used for a longer period.
• Always store the appliance at a well ventilated and dry
place outside the reach of children.
Troubleshooting
Remedy
Check the outlet with a different device.
Insert the power plug correctly.
Check your domestic fuse.
Contact our Service or a specialist.
Select a fruit type producing more juice.
Juice cannot be extracted from small berries in the filter / blade (4).
Check that all components have been installed correctly.
in-between.
Storage
33