Installation; Assembly - elco klockner EK02B.12 Betriebsanleitung

Installation

Assembly

4
Burner
The burner is secured on the boiler with
the flange supplied. The drilling
recommended for Ø b is written in
boldfaced figures on the drawing. If Ø a
on the boiler exceeds the maximum Ø
on the drawing (see technical data),
provision should be made for a cover
plate in front.
· Mount the flange and its gasket on
the boiler.
· Check the tightness.
The burner is assembled in position 1.
If necessary, it can be assembled in
position 2 or 3.
· Insert the burner's end piece into
the flange (penetration: see Boiler
Instructions).
· Tighten the collar while gently lifting
the burner.
· If necessary, unclip the name plate,
rotate by 180° and clip back onto
the hood.
When the generator incorporates a
door for access to the furnace, pack the
space 4 between the quarl and the
blast tube with a refractory material (not
supplied).
01/2005 - Art. Nr. 13 017 870A
EN
5