Inhaltsverzeichnis; General Information; Guarantee, Safety; Main Statutory Instruments - elco klockner EK02B.12 Betriebsanleitung

General information

Contents

Guarantee, safety

Main statutory instruments

Contents
General information
Guarantee, safety................................3
Main statutory instruments ..................3
Burner description, packaging.............4
Technical data
See technical data Nr 13018095
Installation
Assembly .............................................5
Fuel-oil connection ..............................6
Electrical connection............................6
Pre-start-up checks .............................6
Start-up
Checking and setting
combustion components,
secondary air.......................................7
Setting nozzles ....................................7
Description and settings
Combustion air ....................................8
Safety units characteristics................10
Safety units diagrams........................11
Options of connection .......................12
Electric connection box ................13-14
Description and settings,
fuel-oil pump......................................15
Firing.................................................. 16
Setting and checking the safety
devices ..............................................16
Maintenance .....................................17
Troubleshooting ..............................18
Guarantee
Installation and start up must be
performed in accordance with current
accepted practices by a technician.
Current regulations, as well as the
following instructions must be complied
with. Any failure, however minor, to
observe these provisions shall absolve
the manufacturer from any liability.
Also see:
guarantee enclosed with burner,
-
conditions of sale.
-
Safety
The burner is designed for installation
on a generator connected to correctly
functioning exhaust flues.
It should be used in an area where there is
an adequate supply of combustion air and
where polluted products can be properly
evacuated.
Flue size and design must be
appropriate to the fuel in compliance
with the current regulations and
standards.
The control and safety unit and the
cut-outs used require a power supply of
+10 ±1%
230 VAC % 50Hz with an earthed
-15
neutral wire.
It must be possible to isolate the burner
from the network by means of a
multipole switch complying with the
current standards.
Maintenance staff should always act
with extreme caution and in particular
avoid direct contact with electrical
circuits and with parts not fitted with
heat insulation.
Avoid splashing water on the electrical
components of the burner.
In the event of flood, fire, fuel leak or
abnormal operation (suspicious smell,
or noise, etc.) switch off the burner, turn
off the power and fuel supplies and call
in a qualified specialist.
It is essential that all furnaces and
accessories, waste gas ducts and
connection pipes are serviced, cleaned
and swept once a year and before
burner start-up. See the applicable
regulations in force.
01/2005 - Art. Nr. 13 017 870A
Declaration of conformity
for fuel oil burners
We, CEB
F-74106 ANNEMASSE Cedex, France
declare under our sole responsibility
that the following products:
EK02B.12L
EK02B.16L / EK02B.16L-Z
EK02B.21L-Z
comply with the following standards:
EN 60335
EN 50081
EN 50082
EN 267
Belgian Royal Order of Jan. 8th
2004
Within the terms of following
directives:
89 / 392/EEC Machine directive
89 / 336/EEC EMC directive
73 / 23 /EEC Low-voltage
device directive
92 / 42 /EEC Operating efficiency
directive
These products bear CE-marking
Annemasse, 1st November 2004
J.HAEP
EN
3