ROWENTA Silence Force Cyclonic Bedienungsanleitung Seite 15

751271_SF Cyclonic_16L_751271 08/12/10 11:23 Page15
2 • If you have the automatic
model*: automatic cleaning of
the HEPA filter and emptying of
the dust container
Cleaning is performed automatically and requires
no action from you. It is carried out when required
when your vacuum cleaner is switched on or off.
NOTE: Your vacuum cleaner makes a clicking
noise during the cleaning operation, this is
completely normal
We recommend that you empty the dust container
each time after use and/or after cleaning the filter.
Proceed as follows:
- Unplug your vacuum cleaner and open the cover
by pressing the "OPEN" button
remove the bowl
- Remove the filter assembly composed of the
separator and the filter (3 and 5)
it gently against the side of the bowl to remove
any excess dust
(fig.24)
container
- Clean the separator cover using a cloth is if it is
(fig.25)
dirty .
- Refit the filter assembly (3 and 5) inside the dust
(fig.26)
container
into its housing and close the cover of the vacuum
(fig.27)
cleaner .
REMARK
if you notice that the suction
power of your appliance drops, you can force
the automatic cleaning of the HEPA filter. In
this case, switch off your appliance and press
the ON/OFF button twice consecutively
(fig.28).
IMPORTANT
afterwards.
3 • Servicing the HEPA filter
IMPORTANT
remain unsatisfactory after the mechanical or
automatic cleaning of the HEPA filter
(see Cleaning and maintenance paragraph). In
this case it must be cleaned manually.
(fig.21)
.
(fig.18)
(fig.19)
.
(fig.22)
tapping
(fig.23)
then empty the dust
.
. Then refit the dust container
Empty the dust container
The suction power may still
In this case, open the vacuum cleaner cover
(fig.18)
, remove the dust container and release
(fig.29)
the HEPA filter
Remove the HEPA filter (5) from the separator (3)
(fig.30)
and tap the filter above a dustbin
(fig.31)
then clean the outside wall of the filter
under the cold water tap
WARNING Do not place the inside
wall of the HEPA filter under water.
Do not touch or rub the folds of the HEPA
filter. Leave the HEPA filter to dry for 24H
before refitting it in the appliance.
Refit the HEPA filter in the separator
Lock it in position
and
container into its housing in the vacuum cleaner
and close the cover of the appliance
IMPORTANT
damaged, you may purchase another from
your dealer or from an Approved Service
Centre (see attached list).
4 • Cleaning your vacuum cleaner
Wipe the body of the appliance and the
accessories with a soft cloth. Wash the dust
container and the separator with clean water
(fig.35-36)
then dry them with a soft cloth
(fig.37)
.
IMPORTANT
abrasive detergent
transparency of the dust container and/or the
separator cover may alter in time but this
does not change the performances of the
appliance.
15
EN
.
(fig.32)
.
(fig.33)
(fig.34)
. Refit the dust
(fig.27)
.
If your HEPA filter is
Do not use aggressive or
products. The
.