Care & Cleaning; Troubleshooting - Klarstein 10027056 Gebrauchsanleitung

How to Use the Pulse Function
Since the pressure under the normal vacuum function is set to be high, sometimes it is easy to destroy
some delicate items by high pressure in the vacuum bags. In this case, you can use the „PULSE" vacuum
function to control the vacuum time and pressure, and prevent crushing delicate items. When packing
some juicy foods, you can also use this function and prevent liquid being sucked out.
1. Place the item(s) to be sealed into the pre-cut or custom sized bag. Leave at least 2 inches
between the contents and the top of the bag to allow for bag contraction.
2. Open lid and place the open end of the bag down into the vacuum chamber.
3. Close lid by pressing down on both sides, If the lid cannot be lifted, then you have successfully
locked the lid in place.
4. Press the „PULSE" button continually, till it reaches the pressure that you want. You can watch the
vacuum bag to decide the pressure. During this process, you can stop vacuum by stop pressing
this button ; and press it again to vacuum again.
5. When the pressure reaches what it needs, press „SEAL" button to start sealing.
6. Once the indicator light has turned off, press the release buttons on both sides ofthe machine to
release the bag.
1. Always unplug the unit before cleaning
2. Do not immerse in water.
3. Do not use abrasives to clean the unit.
4. Wipe the outer surface with a soft. damp cloth and soap.
5. To clean the inside ofthe unit, wipe away any food or liquid with a paper towel.
6. Dry all parts thoroughly before you plug in and operate the unit again.
7. Vacuum chamber may trap liquids that were drawn from the bag ; use a mild dish washing soap
and a warm, damp cloth to wipe away any lefi behind liquid from the vacuum chamber.
8. Dry thoroughly.
Nothing happens when I press the „VACUUM" button:
• Make sure the power cord is correctly plugged into the electrical outlet.
• Make sure the power cord is not damaged in any way.
• Make sure the electrical outlet is operative by plugging in another appliance. If it's not,
• please check the circuit breakers or fuses in your home.
• Make sure the bag is positioned correctly down in the vacuum chamber.
• Press down on both sides ofthe lid and make sure it is locked in place.
• Wait 25 minutes to allow appliance to cool off, and then try using again.
Air is not vacuumed from the bag:
• Check that there are no gaps. folds, wrinkles or holes in the pre-sealed bags.
• Check for loose, worn or cracked Upper and Lower sealing gaskets.
• Foods with high liquid contents may prevent the bag from sealing properly. Cut bag open and wipe
top inside of bag and reseal.
• Check to see if bag is properly inserted into the vacuum chamber.
• Make sure you've placed the bag in the proper place. When making a bag from a roll, make sure
end of cut piece is on the sealing strip.
Bag melts:
• The sealing strip may have been too hot during the sealing process. Allow the unit to cool for 20
seconds between uses. lithe bag continues to melt. allow unit to cool with the lid in the upright
position for 25 minutes before using.
Care & Cleaning

Troubleshooting

12