Klarstein 10027056 Gebrauchsanleitung Seite 11

1. VACUUM button
Press to vacuum package and seal food airtight. Appliance shuts off automatically.
2. CANCEL button
Immediately halts the current function.
3. PULSE button
ls used when extreme control ofthe vacuuming process is needed for delicate foods.
Press the button and the vacuum pumps turns on, release the button and it shuts off .
4. SEAL button
1. Press to create a seal when making bags from bag roll.
2. Press to immediately stop the vacuum process and begin sealing the bag. Preventing
delicate
foods from being crushed.
3. Press to create a seal on foil bags (such as a potato chip bag) to keep food sealed airtight.
5. SEALING LINE
Do not tearthe high-temperature resistant tape away.
6. ACCESSORY PORT
Allows vacuum packaging with Canisters and Accessories.
7. VACUUM CHAMBER
Make sure to place the open end of the bag down into the vacuum chamber for successful vacuuming
8. SEALING GASKETS
HOW TO MAKE CUSTOM SIZED BAGS
1. Pull enough bag material to hold item to be vacuum packaged, plus 2 inches. Vlfith a pair of
scissors or sharp knife, cut desired bag length from bag roll. Make sure to cut in a straight line.
Plug in power cord.
2. Open lid. Place one end of out bag onto sealing strip, don't worry if you accidently place any
material onto the gasket area.
3. Close lid by pressing down on both sides. If the lid cannot be lifted. then you have successfully
locked the lid in place.
4. Now that lid has been locked, press the „SEAL" button to create a custom sized bag. The indicator
light illuminates during the seal process.
5. Once completed the indicator light will turn off ; press the release buttons on both sides of the
machine, it is now sate to take out the newly created bag.
6. The custom sized bag is now ready forvacuum sealing.
CAUTION: Make sure you give the appliance time to cool down. Wait CAUTION: Make sure you give the appliance time to cool down. Wait
at least 20 seconds between seals. Under very heavy usage, appliance at least 20 seconds between seals. Under very heavy usage, appliance
will shut off automatically to prevent overheating. If it does, wait 25 will shut off automatically to prevent overheating. If it does, wait 25
minutes to allow appliance to cool off .
HOW TO VACUUM SEAL WITH THE VACUUM BAGS
1. Place the item(s) to be sealed into the pre-cut or custom sized bag, Leave at least 2 inches
between the contents and the top of the bag to allow for bag contraction.
2. Open lid and place the open end of the bag down into the vacuum chamber.
3. Close lid by pressing down on both sides. If the lid cannot be lifled, then you have successfully
locked the lid in place.
4. To begin the vacuum process, press the „VACUUM" button. The unit will continue to vacuum and
then seal once air has been removed.
5. Once the indicator light has turned off . press the release buttons on both sides ofthe machine to
release the bag.
11