Axis P3364–VE Installationsanleitung Seite 23

The illustration below shows an indoor variant.
1
Locking screw
2 Lens holder
3
Lens
4
Screws
1. Open the Live View page, see Access the Product on page 25.
2. Loosen the two screws.
3. Check the Live View page and tilt the lens to the desired position.
4. If the lens needs to be tilted more than 90°, do the following:
- Loosen the locking screw.
- Rotate the lens holder 180°.
- Fasten the locking screw.
- Tilt the lens.
5. Tighten the two screws.
Adjust Focus and Zoom
NO NO TICE NO TICE TICE
Adjusting focus and zoom manually can damage the lens.
Note
• Due to the dome's refraction, the image may appear slightly out of focus once the dome
has been placed. To correct this go to the Focus Adjustment web page under Setup >
Basic Setup > Focus & Zoom, and adjust the focus again.
Open the Focus Adjustment page in the web interface under Setup > Basic Setup > Focus &
Zoom, and follow the on-screen instructions. Use the image window to adjust the focus and zoom.
See the online help files for more information.
AXIS P33–VE Network Camera Series
23