Axis P3364–VE Installationsanleitung Seite 18

AXIS P33–VE Network Camera Series
If a cable other than the provided cable is used, you need to prepare a network cable with a gasket.
Gently push the cable through the gasket provided and attach a network connector. It may be
necessary to pierce a hole in the gasket with the resistorx L-key.
Replace Clear/Smoked Dome Cover (Optional)
The Axis product is supplied with an optional dome. To replace the dome cover:
1. Loosen the four screws under the dome cover that hold the dome in place.
2. Replace the old dome with the new. Make sure the rubber gasket sits securely in place
and tighten the screws.
Route the Cables
The cables can be routed in the following ways:
• Through the wall, see Route the Cables through the Wall on page 19
• Along the wall, see Prepare the Unit Casing on page 19 and page Route the Cables along
the Wall on page 20.
18