Processor Reset; Sleep Timer - Sherwood R-607 Bedienungsanleitung

Adjusting the Channel Volumes
In addition to using the AVR's built-in test noise to
configure the AVR for your speakers as explained
in Configure the AVR for Your Speakers, you can
also adjust the volume of any channel at any time to
compensate for individual program sources or your
personal taste.
1
Press the remote's Channel Level button. The
Message Display will show the left channel
volume level.
2
Use the remote's up and down arrow buttons to
display the channel you want to adjust.
3
Use the remote's left and right arrow buttons to
adjust the channel's volume.
Press the RETURN button when you're finished.
Recording
Two-channel analog audio signals, as well as composite
video signals, are normally available at the appropriate
recording output connectors. To make a recording,
connect your audio or video recorder to the appropriate
AVR output connectors as described in the Making
Connections section, insert blank media in the recorder
and make sure the recorder is turned on and recording
while the source is playing. Refer to the recording
device's instructions for complete information about
making recordings.
Note
• The AVR does not convert digital signals to
analog. Only devices connected to the analog
audio and composite video input connections can
be recorded.
• HDMI video sources are not available for
recording.
• Please make certain that you are aware of any
copyright restrictions on any material you record.
Unauthorized duplication of copyrighted materials
is prohibited by law.
Sleep Timer
The sleep timer sets the AVR to play for up to
90 minutes and then turn off automatically.
Press the Sleep button on the remote, and the time until
turn-off will be displayed on the front-panel Message
display The available settings are 30 min., 60 min.,
90 min. and OFF.
When the sleep timer has been set, a small crescent-
moon icon will appear on the front-panel display.
If you press the SLEEP button after the timer has been
set, the remaining play time will be displayed. Press the
SLEEP button again to change the play time.

Processor Reset

If the AVR behaves erratically after a power surge, first
turn off the front-panel Main Power switch and unplug
the AC power cord for at least 3 minutes. Plug the cord
back in and turn the AVR on. If this procedure doesn't
help, reset the AVR's processor as described below.
Note
• Resetting the processor will erase all user
configurations, including speaker and level
settings, and tuner presets. After a reset, reenter
all of these settings from your notes in the
Appendix worksheets.
To reset the AVR's processor:
1
Press the front-panel Standby/On switch to
place the unit in the Standby mode (the Standby
Indicator LED will turn red).
2
Press and hold the SURROUND down button on
the remote control as pressing and holding the
front-panel Standby/On switch simultaneously.
3
When the RESET message "RESET?" appears
on the front-panel Message display, press
BAND.
4
When the RESET message "OK?" appears on
the front-panel Message display, press BAND.
Memory
If the AVR is unplugged or experiences a power outage,
it will retain your user settings for up to two weeks.
Operation
19