Sherwood R-607 Bedienungsanleitung Seite 15

4
Select "Speaker Settings". The Speaker Settings
menu will appear.
1a. SpeaKer Setting's
Front
Center
Surrround L/R
Subwoofer
5
Use the remote's left and right arrow buttons
to select NO, SMALL or LARGE for the Front,
Center and Surround speaker positions,
depending on the speakers you have connected
to the receiver.
NO: Select this setting if you have not connected
a speaker in that position (not available for the
Front speakers).
SMALL: Select this setting if the speaker is not
capable of producing clean, deep bass energy
at output levels that match those produced by
a powered subwoofer. All bass in that channel
is removed from that speaker and is sent to the
subwoofer (or to the Front speakers if Subwoofer
is set to NO). Most speakers (unless they are
large and powerful) should be considered
SMALL.
LARGE: Select this setting if the speaker is
capable of producing clean, deep bass energy
at output levels that match those produced by a
powered subwoofer. All bass in that channel is
sent to that speaker.
When you're finished, press the remote control's
RETURN button to return to the Speaker Setting
menu.
Note
• If your system has a subwoofer and you set the
Front speakers to LARGE, the subwoofer may
not output audio except for Dolby Digital and
DTS encoded program material that contains
LFE channel information. If you set your
Front speakers to LARGE and you want your
subwoofer to reproduce bass from all program
material, set the Subwoofer to PLUS (see below).
• For Subwoofer, select YES (if your system has
a subwoofer), NO (if your system does not
have a subwoofer), or PLUS (if your system
has a subwoofer, you set your Front speakers
to LARGE and you want your subwoofer to
reproduce bass from all program material).
6
7
< LARGE >
[ LARGE ]
[ LARGE ]
[ YES ]
8
9
10
11
12
For now you can skip the "Crossover" setting.
Select "Speaker Distance". The Speaker
Distance menu will appear.
1d. SpeaKer Distance
Units [ FEET ]
Front L < 10.0ft >
Center [ 10.0ft ]
Front R [ 10.0ft ]
Surrround R [ 10.0ft ]
Surrround L [ 10.0ft ]
Subwoofer [ 10.0ft ]
Note
• The unit display may differ depending on the
distributed models.
Measure the distance from each speaker in your
system to the listening position. Write down the
distances.
Use the remote's left and right arrow buttons to
change the distance setting for each speaker so
it matches the distance you wrote down in step 8.
When you're finished, press the remote control's
RETURN button to return to the Speaker Setting
menu.
Select "Channel Level". The Channel Level
menu will appear. Use the remote's left and
right arrow buttons to set Test Tone to "Manual"
and press the remote's ENTER button. After the
on-screen countdown you will hear test noise
through the front left speaker.
1c. Channel Level
Test Tone < Manual >
Sit in the main listening position and adjust
the AVR's volume control so the test noise
is moderately loud. Note the volume of the
test noise through the first speaker. Press the
remote's down arrow button to advance the
test noise to each of your system's speakers
and note the volume level of the noise in each
speaker.
As you advance the test noise through the
speakers, use the remote's left and right arrow
buttons to adjust the volumes of the channels
until all of them play at the same volume.
When you're finished, press the remote's SETUP
button to turn of the on-screen menus.
Setup
15