Attaching The Power Switch Cover - Epson TM-T88V Benutzerhandbuch

Attaching the Connector Cover
Follow the steps below to attach the connector cover to protect the cables.
1. Turn over the printer.
2. Position the two hooks on both sides of the connector cover so that they hook
the printer case, as shown in illustration C on page ii.
3. Push the connector cover down to click onto the printer case.
4. Pass each cable through the cable exits at the bottom of the connector cover.
5. Turn over the printer, and make sure the cables are not pinched.
To remove the connector cover, turn the printer over, and push the connector
cover down while pushing both sides of the connector cover inward to detach the
hooks from the printer case. See illustration D on page iii.
Installing Roll Paper
Follow the steps below to install the roll paper. If you want to change the paper
width by using the roll paper guide, see "Changing the Paper Width" on page 5.
1. Press the cover open button to open the roll paper cover. See illustration E on
page iii.
2. Remove the used roll paper core if any, and insert the roll paper. See
illustration F. The correct direction of the paper is shown in illustration G.
3. Pull out some paper, and close the roll paper cover, as shown in illustration H.
4. Tear off the paper, as shown in illustration I.

Attaching the Power Switch Cover

The enclosed power switch cover ensures that the power switch is not pressed
accidentally. To use this cover, install it as shown in illustration J on page iii.
WARNING:
If an accident occurs with the power switch cover attached, unplug the AC
cable immediately. Continued use may cause fire or shock.
Changing the Paper Width
You can change the paper width from 80 mm to 58 mm by installing the roll paper
guide. Follow the steps below to change the paper width.
CAUTION:
If you once change the paper width from 80 mm to 58 mm, you cannot
change it back to 80 mm.
When changing the paper width, be sure to make the setting for the paper
width with utility software for the TM-T88V.
1. Open the roll paper cover.
2. Install the roll paper guide so that the projection on its bottom is aligned with
the hole at the right of the roll paper holder, as shown in illustration K on
page iv.
3. Tighten the enclosed screw to fix the roll paper guide.
TM-T88V User's Manual 5
English