Removing Jammed Paper - Epson TM-T88V Benutzerhandbuch

English
4. Paste the enclosed 2 sheets along the roll paper guide on the bottom of the roll
paper holder, as shown in illustration L.
Make sure the space between the top edge of sheet and the line of the groove
in the roll paper guide (indicated as a in the illustration) is 0.5 mm or less.
5. Install the roll paper correctly.
6. Close the roll paper cover.
Troubleshooting
No lights on the control panel
Check whether the DC cable and AC cable are correctly connected to the printer
and the power outlet.
Error LED on with no printing
❏
Check whether the roll paper cover is closed. If it is open, close it.
❏
If the Paper LED is on, check whether the roll paper is correctly installed and
any roll paper remains.
Error LED flashing with no printing
❏
Check whether a paper jam has occurred. If paper is jammed, remove the
jammed paper referring to the description below and install the roll paper
correctly.
❏
Printing stops if the head overheats and resumes automatically when it cools.
❏
For other cases, turn the printer off, and after 10 seconds, back on.

Removing Jammed Paper

When a paper jam occurs, never pull out the paper forcibly. Open the roll paper
cover and remove the jammed paper.
CAUTION:
Do not touch the thermal head and the frame on its side (indicated in the circle
in illustration O on page iv) because it can be very hot after printing.
If the roll paper cover does not open, follow the steps below.
1. Turn off the printer.
2. Slide the cutter cover toward front to open it, as shown in illustration M on
page iv.
3. Turn the knob until you see a triangle in the opening. This returns the cutter
blade to the normal position. There is a label near the cutter to assist you. See
illustration N.
4. Close the cutter cover.
5. Open the roll paper cover and remove the jammed paper.
6 TM-T88V User's Manual