Waeco PerfectView REC400 Montage- Und Bedienungsanleitung Seite 39

PerfectView REC 400
Setting the acceleration sensor
You can set the acceleration sensor under the menu item „G_Sensor
Setting".
You can make the following settings:
 "G_Sensor Setting" (on/off) activates or deactivates the acceleration sen-
sor
 "G_Sensor Mode" (automobile mode/truck mode/motorcycle mode) sets
the preferred acceleration sensor mode.
 "G_Sensor Sensitivity" (lowest/low/normal/high/highest) defines the sen-
sitivity of the acceleration sensor
➤ Select the required sub-item (see chapter "Navigating through menus" on
page 35).
➤ Use
or to select the preferred setting.
➤ Confirm by pressing
Resetting the video recorder to its default settings
You can restore the factory settings of the video recorder under the menu
item "Default Settings".
➤ Select the required sub-item (see chapter "Navigating through menus" on
page 35).
➤ Confirm by pressing "Yes" or
➤ cancel by pressing "No".
8.3 Making system settings using the software
application
➤ Connect the SD card to a PC using a card reader.
You can make the following settings using the configuration window:
Menu item
Video quality
Video frame rate
Video format
EN
.
Function
Select the video quality:
high/normal/low
Select the recording frequency (frames/second):
2 / 4 / 6 / 8 / 10 / 15 / 20 / 25 / 30
Select the video format: D1 / CIF
Setting the video recorder
39