Setting The Password - Waeco PerfectView REC400 Montage- Und Bedienungsanleitung

Setting the video recorder
Checking the firmware version
You can check the current firmware version under the menu item "Version".
NOTE
I
Start by checking the current firmware before performing an up-
grade.
➤ Select the required sub-item (see chapter "Navigating through menus" on
page 35).
✓ The current version is displayed.
8.2

Setting the password

You can define a four-digit PIN number to password-protect access to the
main menu under the menu item "Password".
➤ Select the required sub-item.
➤ Use
or to select digits for the PIN.
➤ Use
or to select a particular digit within the PIN.
➤ Confirm the "Sure" message by pressing
Configuring alarm inputs
You can make the settings for the alarm inputs under the menu item "Alarm".
Each alarm input can be allocated to each camera input. Two alarm inputs
can be allocated to the same camera input.
The alarm inputs feature priorities in descending order, from 1 to 4. In the
event of two simultaneous alarm impulses, the alarm input with the high pri-
ority is shown first, with the respective channel being displayed.
➤ Select the required sub-item (see chapter "Navigating through menus" on
page 35).
➤ Use
or to select the preferred camera input.
➤ Use
or to select the preferred alarm input.
➤ Confirm by pressing
38
.
PerfectView REC 400
.
EN