FALMEC AURA Bedienungssanleitung Seite 23

When the hood is in place, fully tighten the 4 "V2" screws. Tighten the 4 "V4" safety
screws to further lock the hood body to the "SP" support.
Fig. E
Fasten the "VC" glass sleeve to the hood using 4 "V5" knurled metric pins and connect the
keyboard terminal to the hood electronics as shown in the figure.
Fig. F
Hook them to hood door "P" and side components "EL" as shown in the figure.
Fig. G
Fasten the hood to components "EL" and carbon filters "FC", as shown in the figure (pay
ATTENTION to the assembly direction of the filters: see figure G2).
Fig. H
Insert the grease-trapping metal filter kits as shown in the figure. Close door "P" and
switch on the hood power supply complying with the current standards.
21