FALMEC AURA Bedienungssanleitung Seite 20

5: 4th Speed
By pressing the key (long press or not), if the LED is off and another speed is active,
you can select the 4th speed, turn the related LED on, and turn the LED associated to the
previously selected speed off.
If the LED is off and no speed is active, pressing the key has no effect.
When the LED is on, pressing key 5 has no effect.
The fourth speed must remain on for a maximum of 7 minutes, after which it must
return to the third.
To turn off the hood, first select the 1st speed, then press that key again.
6: Light – Associating a radio control
Light: By shortly pressing T6 key, you can turn the light on and off. T6 key will light up
if the light is on.
Associating a radio control: Applying prolonged pressure on T6 key with the motor
and light off will enable the remote binding mode. T6 key will flash for a maximum of 10
seconds. During flashing, at least one radio control key must be pressed. The function
will deactivate at the end of the 10 seconds, or earlier if a compatible remote control is
detected.
Key pressure management :
Prolonged pressure = finger on key for at least 3 seconds, the function activates during
pressure.
Non-prolonged pressure = finger on key for less than 3 seconds, the function activates
when it is released.
Radio control: Place the device far from sources of electromagnetic waves which could
interfere with the hood electronic functions.
Maximum operating distance 4 metres. This distance may vary in defect based on the
electromagnetic interference of other devices.
Radio control operation
Light Key By pressing the Light key, the light is switched on/off
Key ' - ' By pressing the '-' key, the motor speed is decreased. If the 1st speed is active, by
pressing the '-' key, the motor is turned off.
' + ' Key
If the motor is turned off, by pressing the '+' key, the motor is enabled at the 1st speed.
If the motor is running, by pressing the '+' key, the motor speed is increased to the top.
Timer Key If the motor is active, by pressing the timer key the timer function is enabled/
disabled
Code Change
(only in case of malfunction)
Press the "Luce" (Light) key together with the "Timer" key of the radio control until the
blue LED begins to slowly flash. If the "-" key of the radio control is pressed within 5 sec-
onds, the new code will be generated and memorized. Memorisation is confirmed by 3
short flashes of the LED.
To return to the default code, press the "-" and "+" keys together for over 5 seconds. The
default code memorization of the default code will be signalled with 3 short flashes of
the LED.
henever a new code is generated or the default code is set in the remote control, it is
necessary to also carry out the previously described procedure related to Associating a
radio control (Light Key of the push button control panel).
18