WAGNER W 670 Handbuch Seite 20

GB
working conditions and the activity to be carried out into consideration. The
use of power tools for purposes other than the intended ones can lead to dangerous
situations.
5. Service
a) Have your tool repaired only by qualified specialist personnel and only with
original spare parts. This ensures that the tool safety is maintained.
b) If the supply cord is damaged, it must be replaced by the manufacturer or it's
service agent or a similarly qualified person in order to avoid a safety hazard.
Safety Instructions for Spray Guns
•
Caution!
Wear breathing equipment: Paint mist and solvent vapors are damaging to
health. Always wear breathing equipment and only work in well ventilated rooms or
using supplementary ventilating equipment. It is advisable to wear working clothing,
safety glasses, ear protection and gloves.
CAUTION: DANGER OF INJURY!
Never point the spray stream towards human beings or animals.
•
The spray gun is to be used only for paints and solvents with a 21 °C (32° in UK)
flashpoint or higher (See information on the material tin. Hazard class A II and A III
permitted).
•
Do not use the spray guns to spray flammable substances.
•
The spray guns are not to be cleaned with flammable solvents which have a flashpoint
under 21 °C.
•
Caution against dangers that can arise from the sprayed substance and observe the
text and information on the containers or the specifications given by the substance
manufacturer.
•
Do not spray any liquid of unknown hazard potential.
•
The device may not be used in workplaces covered by the explosion-protection
regulations.
•
To avoid the hazard of explosion when spraying, provide for effective natural or
artificial ventilation.
•
There must be no sources of ignition such as, for example, open fires, smoke of lit
cigarettes, cigars and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the
vicinity during spraying.
•
Ensure that no solvent vapors are sucked in by the unit. Do not spray onto the unit!
•
The spray gun is not a toy; children must therefore not be allowed to handle it or play
with it.
•
Before working on the spray gun remove the power plug from the socket.
•
Cover areas that are
example, may transport paint mist over great distances and cause damage.
•
The units may only be used with a functional valve.
hose (Fig. 12 A, item 14) do not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the diaphragm if necessary.
•
Do not lay the spray gun.
•
The device is equipped with a thermal release which disconnects the device in case of
overheating. In this case, turn off the device, remove the plug and let the device cool
down for at least 1/2 hour. Eliminate the cause of heating, e.g. bent hose, soiled air filter,
14
not to be sprayed. When working keep in mind that wind, for
If paints rises in the ventilating
W 670