Machine Charging - Numatic CRO 8055/100T Originalanleitung

!
The battery charge indicator displays the charge level of the batteries;
when fully charged, all meter lights are illuminated.
As the machine is used and the batteries are discharged, the meter lights will go out from right to left.
If the battery-charge level is allowed to discharge to the point that only three red lights are illuminated, the operator must
consider charging the machine.
If the battery-charge level is allowed to discharge to the point that only three red lights remain illuminated (and begin
to flash), all cleaning functions will automatically be disabled and the operator should drive the machine straight to a
suitable charge point.
50-100%
56
The large capacity gel batteries are sealed for life and are totally maintenance free. The on-board charger
automatically monitors the charging process and will switch off when the batteries are fully charged.
The machine charging point is located above the foot plate (See page 3 : Item 10).
Insert the charging lead (Fig.56) required for your country into the charging point and connect to a suitable power
supply (Fig.57).
Note: The Charging Lead supplied with your machine may differ than the lead shown.
Once the charging lead has been connected the red charging indicator will illuminate and the display panel will show
'INHIBITED'.
The battery charge indicator display lights will flash in unison.
The machine will not operate.
To ensure a full charge, the machine should be left until the charging indicator shows green.
Once fully charged, disconnect the charging lead from both the power supply and the machine.
*Note
Charger viewing panel only available on certain models.

Machine Charging

Always ensure that the machine is switched off prior to charging.
20-50%
40
!
0-20%
57
See page 44