Filling The Clean-Water Tank; Fill Level Indicator - Numatic CRO 8055/100T Originalanleitung

!
Always ensure that the machine is switched off before making any adjustments

Filling the Clean-water Tank

The CRO 8055 is equipped with a large capacity 80 litre clean water tank, allowing for large areas to be covered in a
single fill.
22
To fill the clean water tank extend the Flexifill hose, remove the rubber seal and fill from a suitable water outlet (Fig.22).
Replace seal and hose to original position when finished.
Alternatively unscrew the filler cap completely (Fig.23) and fill the tank using a hose or preferred method (Fig.24).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter
the clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free
from debris.

Fill Level Indicator

When filling the clean water tank, do not fill above the clean water tank emptying hose retaining clip (Fig.25).
This can be found at the rear of the machine.
!
Machine Set-Up
23
25
If you need to access the batteries, make sure that the
waste-water tank is empty before lifting.
22
24
!
!