Removing / Attaching The Cover; Using The Baby Insert; Care Instructions - Concord Ultimax I-Size Einbau- Und Bedienungsanleitung

_ REMOVING / ATTACHING THE COVER

To remove the cover the seat (A) has
to be removed from the base (B) (see
„REMOVING THE SEAT").
Loosen the rubber bands and push buttons
of the cover, which are located in the
places marked red on the reverse side of
the cover.
Open the harness buckle (02).
First remove the cover from the head
support (01).
Thread the harness buckle (02)
through the harness buckle cushioning
and out underneath the cover.
Open the Velcro fastener on the
harness guides and remove the cover
from the seat.
The covers are attached in reverse
order.
Check that all the locks are closed and all anchorings are correctly
fastened.
34

_ USING THE BABY INSERT

_ CARE INSTRUCTIONS

Light dirt can be easily removed with a damp cloth. The cover can also be
removed and washed at 30°C. Remove the back cushion from the cover of the
head support before you wash it.
Prior to washing the baby insert, remove the comfort foam piece from the pocket
at the back of the baby insert. Remember to insert the foam into the pocket
again before using the baby insert.
The cover material colour may run slightly when wet, in particular during
washing.
The pre-installed baby insert should be
removed, if the child's height exceeds
60 cm.
A comfort foam is placed in a pocket at the
back of the baby insert. This comfort foam
is enhancing the safety and comfort of your
baby. Do not remove the foam unless for
cleaning purposes. Always use it when using
the child restraint in vehicle.
Please guide the harness belts through its
corresponding openings when installing
the baby insert in your CONCORD ULTIMAX
I-SIZE.
Do not use solvents on the cover!
35