Mounting The Seat Opposite To The Driving Direction (From 40 - 105 Cm) - Concord Ultimax I-Size Einbau- Und Bedienungsanleitung

_ MOUNTING THE SEAT OPPOSITE TO THE DRIVING DIRECTION
(FROM 40 - 105 CM)
CAUTION!
Do not use on seats with
airbags. Danger to life!
Always mount the seat
without a child in it!
Guide the seat (A) as shown,
opposite to the driving
direction over the base (B).
First mount the frame of the
seat into the seat lock (12) of
the I-Size base.
Then fold the seat forward until
the front seat lock (11) audibly
locks into the I-Size base and
the safety display (07) on the
top is green.
26
CLICK
CAUTION!
• Make sure that the seat is correctly
anchored to both anchoring points and
the safety display (07) is green!
• If the child's height exceeds 60 cm,
the pre-installed baby insert should
be removed (see „USING THE BABY
INSERT").
Push the child seat backwards
onto the ISOFIX receptacles
until the locking mechanisms
of both ISOFIX adapters (15)
audibly lock into place and the
safety displays (14) on both
adapters are green!
Turn the ISOFIX SYSTEM (08) control
dial to the right until the CONCORD
ULTIMAX lies as close/flush as
possible to the back rest of the car
seat.
Push the release button (09) of the upper leg support
adjustment outward and position the leg support (10)
for it to rest securely on the floor and the safety display
shows GREEN.
If necessary, the lower leg support adjustment needs to
be used as well.
Release the control button (09) to lock the leg support
in place.
CAUTION!
• The seat must be secured with the ISOFIX
SYSTEM even if no child is travelling!
• Both ISOFIX adapters (15) must be locked
securely in place and the safety displays
(14) on both adapters must show green.
• The support leg (10) must rest securely on
the floor and be locked into place.
27