Removing The Seat; Mounting The Concord Ultimax - Concord Ultimax I-Size Einbau- Und Bedienungsanleitung

_ REMOVING THE SEAT

The seat (A) of the CONCORD ULTIMAX can be removed from the I-Size base (B).
Always remove the child first before removing the seat!
Move the reclining adjustment operating
lever (05) at the front of the seat upwards
and bring the seat into an upright position.
The unlocking mechanism of the seat lock (06) is
at the front underneath the seat on the top of the
I-Size base.
Pull the upper part of the lock (06) forwards and
push the lock down.
Lift the seat up off the base.
24

_ MOUNTING THE CONCORD ULTIMAX

To make mounting easier, we recommend removing the seat (A) of the
CONCORD ULTIMAX from the base (B) (see „REMOVING THE SEAT").
Always mount and remove the CONCORD ULTIMAX without a child in it!
Turn the ISOFIX SYSTEM (08)
control knob on the front of
the CONCORD ULTIMAX I-Size
base to the left until the
ISOFIX adapter (15) on the
reverse is fully extended.
Place the base on an i-Size-compliant vehicle seat facing in driving direction.
Please refer to the instructions provided in chapter „FOR ISOFIX SUITABLE
VEHICLES" and „USING THE CONCORD ULTIMAX CHILD CAR SEAT".
Now reinsert the seat, depending on the height and age of the child either in
the driving direction or opposite to it (see „MOUNTING THE SEAT OPPOSITE TO
THE DRIVING DIRECTION (FROM 40 - 105 CM)" or „MOUNTING THE SEAT IN THE
DRIVING DIRECTION (FROM 76 - 105 CM)").
25