GYS GYSMI E160 Anleitung Seite 14

MADE IN FRANCE
To set the Hot Start, follow these steps :
TIG WELDING WITH INERT GAS (TIG MODE)
TIG welding requires gas shield protection of pure gas (Argon).
electrode has cooled down.
Recommended combinations / electrode grinding
0,5-5
4-7
To optimise the welding process, it is recommended to grind the electrode prior to the welding, as described below:
L = 2,5 x d.
14
GYSMI E160
Press the switch (5) for 3 seconds.
3s
«HS» (Hot Start) blinks and a number is displayed.
Set the desired percentage (display (1)) using the (4) keys.
Validate by pressing the switch (5).
To do TIG welding, follow these steps :
1. Connect the earth clamp to the positive connector (+).
2. Connect a valve torch to the negative connector (–).
3. Connect the torch's gas hose to the gas bottle's regulator
It may be necessary to cut it before the bolt if the latter does not match the regulator.
4. Select the TIG mode (3) with the switch (5).
5. Set the desired intensity (display(1)) using the (4) keys, according to the thickness
of the metal sheet (30A/mm).
6. Set the gas flow on the gas bottle's regulator then open the torch's valve.
7. To start the arc : make contact between the electrode and the workpiece.
8. Once done wit the workpiece : quickly lift the torch, stop the gas flow after the
Ø Electrode (mm)
Current (A)
(filler metal)
10-130
130-190
d
Ø Shroud
= Ø wire
1,6
2,4
L
Flow
(mm) (Argon l/mn)
9,8
11
EN
6-7
7-8