Bosch GHO 40-82 C PROFESSIONAL Bedienungsanleitung Seite 15

Continuing Interrupted Planing
The integrated park rest 23 also allows for contin-
ued planing at any given location on the work-
piece after an interruption:
– With the park rest folded down, place the ma-
chine on the location of the workpiece where
the planing is to be continued.
– Switch the machine on.
– Apply the supporting pressure onto the front
part of the planer base plate and slowly push
the machine forwards ( ). This tilts the park
rest 23 up ( ) so that the rear part of the
planer base plate 13 faces on the workpiece
again.
– Guide the machine alongside the surface to be
planed ( ) with an even feed.
Beveling Edges
The V-grooves 14 in the front planer base
plate 13 allow quick and easy beveling of work-
piece edges. Depending on required bevel width,
use the corresponding V-groove.
For this, place the planer with the V-groove 14
onto the edge of the workpiece and guide along
the edge.
Groove to be
used
None
Small
Medium
Large
15 • 2 609 932 232 • TMS • 23.03.04
Using the Parallel/Beveling Guide
(Accessory)
Mount parallel guide 15 or beveling guide 19 to
the machine using fastening bolt 16 and rebating
depth stop 2 using fastening bolt 1.
Loosen locking nut 17 and adjust the required re-
bating width with the scale 18. Retighten locking
nut 17 again.
Adjust the required rebating depth accordingly
with the rebating depth stop 2.
Carry out the planing procedure several times,
until the required rebating depth is reached. Pay
attention that the planer is guided with sideward
supporting pressure.
14
Beveling (only beveling guide 19)
Replacing the Planer Blade
Dimension a
(mm)
0 – 5.7
1.9 – 7.6
4.7 – 10.3
5.9 – 11.6
The carbide blade (TC) has 2 cutting edges and
can be reversed.
When both cutting edges are dull, the planer
blade must be replaced. The carbide blade (TC)
may not be resharpened.
English - 4
When beveling rebates and
surfaces, adjust the required
slope angle with the angle
adjustment 20.
Before any work on the machine itself, pull
the mains plug.
Be cautious when replacing the planer
blades: Possible danger of injury due to the
sharp cutting edges of the planer blades!
Do not grasp the planer blades by the cut-
ting edges.
Use only original Bosch carbide blades
(TC).