Bosch GHO 40-82 C PROFESSIONAL Bedienungsanleitung Seite 14

Adjusting the Planing Depth
The planing depth can be adjusted variably from
0 – 4.0 mm with the adjustment knob 5, using the
planing depth scale 6 (scale graduation =
0.1 mm):
Rotation in counterclockwise direction
reduces the planing depth
Rotation in clockwise direction
creases the planing depth
Dust/Chip Extraction
(see figure
A
Before any work on the machine itself, pull
the mains plug.
The dust that is produced while working can
be detrimental to health, inflammable or ex-
plosive. Suitable safety measures are re-
quired.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust /chip extraction
and wear a dust protection mask.
Clean the chip ejector 3 regularly. Use a suitable
tool (e. g. piece of wood, compressed air, etc.) to
clean clogged chip ejector. Do not allow fingers to
enter the chip ejector 3.
To ensure optimum extraction of chip /dust chips,
attach the vacuum hose 21 or the chip/dust
bag 22 tightly onto the chip ejector 3.
External Dust Extraction
The chip ejector 3 fits on both sides for direct
connection of the Bosch vacuum hose Ø –
35 mm 21 (accessory). When using other vac-
uum hose systems a suitable extraction adapter
may be required.
The vacuum cleaner must be suitable for the ma-
terial to be worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
14 • 2 609 932 232 • TMS • 23.03.04
)
Integrated Dust Extraction
A chip/dust bag 22 (accessory) can be used for
smaller jobs.
Empty the chip/dust bag regularly. Remove the
chip/dust bag, open the zipper and empty the
= chip/dust bag.
Choice of Chip Ejector Side
= in-
(Right/Left)
The chip ejector 3 can be switched to the right or
left with the selector lever 7.
Always press the change lever until it engages in
the end position.
The selected ejector direction is marked with an
arrow.
Operating Instructions
Park Rest (see figure
The park rest 23 allows the machine to be set
down directly after operation, without danger of
damaging the working surface or the planer
blade.
When planing, the park rest 23 is tilted upwards
thus enabling full contact of the rear part of the
planer base plate 13.
Planing (see figure
Set the required planing depth and place the front
part of the planer base plate 13 against the work-
piece.
Caution! Danger of kickback!
Apply the machine to the workpiece
only when switched on.
Switch the machine on and guide the machine
with an even feed over the surface to be planed.
To achieve high-grade surfaces, work only with
low feed and apply pressure on the centre of the
planer base plate.
When machining hard materials (e. g. hardwood)
as well as when utilising the maximum planer
width, set only low planing depths and reduce
planer feed, as required. Repeat the planing sev-
eral times.
Excessive feed reduces the surface quality and
can lead to rapid clogging of the chip ejector.
Only sharp blades achieve good cutting capacity
and give the machine longer life.
English - 3
)
B
)
B