Auto Charging Docking Station; Recharger Display And Control Panel - Fakir ROBERT-L Bedienungsanleitung

7. Auto Charging Docking Station:

7-1 Recharger Display and Control Panel:

Overall Display
7-2 Using Method & Functional Status of the Docking station:
No. Function Guide
1 LED decorative light
2 Decorative light switch
3 Power LED
4 Charging indicator
5 Signal transmitting
6-7 Recharging positive
& negative electrode
8 Charging power DC
socket
Some essence may damage the plastic surface, so please make
purchase and use after consideration.
ROBERT-L
Function Instructions
1． LED decorative light (a little essence can be placed above)
2． Decorative light switch
3． Power LED
4． Charging indicator
5． Signal transmitting
6． Charging positive pole
7． Charging negative pole
8． Charging power DC socket
Function Information
Turn on the decorative light to activate the atmosphere, and
place in the glowing center of the light a little essence,
which will give off charming aroma after heating.
Press the switch to turn on/off while the decorative light is on.
The Power LED will light when the Docking Station is
connected with the power, or turn off if not connected.
The indicator will flicker while the recharger is connected
with the cleaner.
Transmitting signal is the only way to lead the cleaner to
return the Docking Station for charging, so the signal
transmitting position should be clean for long without any
obstacle on it.
The electrode and that of the Cleaner are connected to
charge under contact mode, so the position should be
clean without any obstacle on it while using, or there will be
impact to the charging.
The power DC socket, called recharger for short, used to
connect output terminal DC24V of the adaptor, is the
charging transit station between the Cleaner and adaptor, so
the recharger should be placed against the wall firmly and the
adaptor cable should be away from the recharger, or the
Robot may have impact and winding during cleaning.
GB
71