Stadler Form Oskar Gebrauchsanweisung Seite 10

• the appliance is not splash-proof.
• do not store or operate the appliance outdoors.
• store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
Preparation for use/operation
1. Place the Oskar room humidifier on a flat surface in the desired area. Plug
the mains cable (3) into a electric socket. Use the filling opening (9) to fill the
lower part (2) with water up to the maximum mark, either at a water tap or
with a watering can. when you have filled the lower part at the tap, carefully
fit the upper part (1) to the lower part (2).
2. next start the appliance by pressing the on/off switch (5). the blue Led
should then light up. if a red pilot lamp lights up however, this indicates ei-
ther lack of water in the appliance or failure to seat the upper part correctly
on the lower part.
3. By pressing the speed level selector button (6) you can change the humidity out-
put (a blue lamp for normal evaporation, two blue lamps for high evaporation).
4. you can use the hygrostat to set the desired air humidity. to do this, press on
the hygrostat button (7). you can choose between the following levels: 40%
relative air humidity (1 blue lamp), 45% (2 blue lamps), 50% (3 blue lamps),
55% (4 blue lamps), constant operation (5 blue lamps). if the lamps are flash-
ing, this indicates that the desired air humidity has already been reached.
the hygrostat switches on automatically once the relative air humidity in the
room sinks below the preset value. we recommend that you set your room
humidity to 45% (comfort range).
5. if you find the lamps too bright (in a bedroom for example), you may reduce
the light intensity by pressing the night mode key (8). the night mode can be
switched off by pressing the key once again.
6. you can use the Oskar air humidifier to distribute fragrances in the room.
Please be as economical as possible in the use of fragrances, because exces-
sive quantities may lead to malfunctions and damage to the appliance. to
use fragrances, remove the fragrance container (10) from the filling opening
(9). Place no more than 2-3 drops of fragrance in the container and replace
it in the space provided in the filling opening. if you wish to change the fra-
grance, you can wash out the fragrance container and fleece under running
water.
7. if you wish to top up with water during operation, you can open the filling
opening (9) by pressing on it (Push to open). you can then refill the appliance