Cloer 5548 Bedienungsanleitung Seite 8

Basic safety instructions
·
The appliance is intended to be used in household only and using in:
– staff kitchen areas in shops, offices and other working environments
– in farm houses
– by clients in hotels, motels and other residential type environments
– on bed and breakfast type environments.
EN
·
Have repairs of Cloer electronic appliances carried out only by
authorized Cloer specialist dealers or by the Cloer customer service.
Improper repairs can involve substantial dangers for the user.
Furthermore, this will void your warranty claims.
·
Only operate the appliance at household-usual power sockets. Check
if the mains voltage stated on the type plate is up to that of your power
supply network.
·
If the supply cord is damaged, it must be replaced by Cloer, its service
agent or similarly qualified persons in order to avoid a hazard.
·
Pull power plug of the power socket
– in case of a defect.
– if the appliance is not used for a longer time.
– before any cleaning.
·
Only pull at the plug, never at the feed cable.
·
Do not tighten the feed cable too tight as otherwise the appliance is
likely to tip over.
·
Do not stretch the feed cable over sharp edges.
·
Do not use the feed cable for carrying and protect it from heat (hotplate
/ open flame).
·
Appliances can be used by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the appliance
in a safe way and if they understand the hazards involved.
·
Cleaning and user maintenance shall not be made by children unless
they are older than 8 and supervised.
·
Keep the appliance and its cord out of reach of children less than 8
years.
·
Children shall not play with the appliance.
·
Do not use the appliance in outdoor.
·
Protect your appliance from humidity (splash water / rain).
·
Let the appliance cool off before cleaning or stowing away.
·
Do not immerse the appliance in water.
·
Surfaces that are marked with the symbol
use. Do not touch hot surfaces.
·
Attention: The heating element surface is subject to residual heat after
use.
8
are getting hot during