wehncke 10573 Betriebsanleitung Seite 12

Repairs
GB
Although the boat has been manufactured of a reinforced and tough material, it is still pos-
sible to cause holes or fissures and cracks when the boat is handled improperly. For the re-
pair of a small damage, a Repair Set is included in the delivery. For carrying out repair work,
proceed as follows:
1. Clean the surface around the damaged spot by means of clean water and a mild deter-
gent. Allow the spot to be repaired to dry well.
2. Cut a round or oval patch from the repair material supplied. The patch should cover the
damaged spot by about 3 cm over its size.
3. Apply a thin layer of the adhesive agent both on the patch and on the location to be
repaired. Allow adhesive agent to air for about ten minutes.
4. Apply again special adhesive agent on both sides and allow again adhesive agent to
dry for about ten minutes.
5. Place the patch with adhesive agent on the spot to be repaired and press them firmly
together.
6. After another ten minutes, apply adhesive agent all along the edges of the patch.
7. Inflate the boat again only after 24 hours hardening time.
Keep the adhesive agent away from children!
Recycling
Please do not discard a WEHNCKE inflatable article in the domestic waste once such an arti-
cle is no longer used. Our products can all completely be recycled. Please send the article
to us, freightage prepaid. You will in this way render a valuable contribution for the protec-
tion of the environment.
Table 1
Type of boat
Sport
190 – 270
12
Air chamber Working presure
1
2
0.03
0.03
Figure 1