Phottix Strato II Multi Benutzerhandbuch Seite 6

Active group settings will be remembered when the
transmitter is turned off and turned back on.
Setting Channels on the transmitter
1. The Phottix Strato Multi transmitter has 4 transmission
channels
2. Move the Channel Selector Switch to 1, 2, 3, or 4 to
select a channel.
3. Make sure Phottix Strato Multi transmitters and
receivers are set to the same channel.
Setting Groups on the receiver
1. The Phottix Strato Multi receiver has four group
settings.
2. Move the Group Selection Switch to A, B, C or D to
select a group for each receiver.
Setting Channels on the receiver
1. The Phottix Strato Multi receiver has 4 transmission
channels.
2. Move the Channel Selector Switch to 1, 2, 3, or 4 to
select a channel.
3. Make sure Phottix Strato Multi transmitters and
6
receivers are set to the same channel.
Connecting to the camera hot shoe
1. Turn off the camera.
2. Slide the Strato Multi transmitter into the camera's hot
shoe mount.
3. Turn the Strato Multi locking ring until tight.
4. Turn on the Strato Multi transmitter.
5. Turn on the camera and set the shooting mode.
Connecting to the camera sync port by
3.5mm Sync cable (included)
The Strato Multi Transmitter can also be attached to a
camera's PC Sync port if you do not wish to use the hot
shoe.
1. Turn off the camera.
2. Connect a cable to Strato Multi transmitter 3.5mm
port.
3. Connect the opposite end of the cable to the camera's
PC Sync Port.
4. Turn on the Strato Multi transmitter.
5. Turn on the camera and set the shooting mode.