Operation - Makita GA4030R Betriebsanleitung

reverse.
NOTE:

OPERATION

WARNING:
It should never be necessary to
force the tool. The weight of the tool applies ade-
WARNING:
ALWAYS replace wheel if tool is
dropped while grinding.
WARNING:
NEVER bang or hit grinding disc
or wheel onto work.
WARNING:
Avoid bouncing and snagging
the wheel, especially when working corners,
sharp edges etc.
WARNING:
NEVER use tool with wood cutting
blades and other saw blades.
CAUTION:
Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION:
Always wear safety goggles or a
face shield during operation.
CAUTION:
After operation, always switch off
the tool and wait until the wheel has come to a
complete stop before putting the tool down.
CAUTION:
one hand on housing and the other on the side
handle.
Grinding and sanding operation
Fig.11
workpiece.
In general, keep the edge of the wheel or disc at an
Operation with abrasive cut-off /
diamond wheel
-
Optional accessory
WARNING:
When using an abrasive cut-off
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
WARNING:
NEVER use cut-off wheel for side
grinding.
WARNING:
Do not "jam" the wheel or apply
excessive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the wheel
WARNING:
Do not start the cutting operation
in the workpiece. Let the wheel reach full speed
and carefully enter into the cut moving the tool
forward over the workpiece surface. The wheel
started in the workpiece.
WARNING:
During cutting operations, never
change the angle of the wheel.
WARNING:
A diamond wheel shall be oper-
ated perpendicular to the material being cut.
Fig.12: 1.
mond wheel 3.
depressed center wheel.
The direction for mounting the lock nut and the
When installing the abrasive cut-off wheel:
Fig.13: 1.
When installing the diamond wheel:
Fig.14: 1.
model
When installing the abrasive cut-off wheel:
Fig.15: 1.
10 ENGLISH
2.
4.
2.
3.
4. Inner
2. Diamond wheel (Thinner
3. Diamond wheel (4mm
4.
2.
3.
4. Inner
-