Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12
ASSEMBLY
machine is delivered pre-assembled, you only need to mount the diamond blade and blade
The
guard.
12.1
Mounting and changing the diamond saw blade
Plug power connector removed.
Cover the side of worktop fold right up.
splash protection at cut-off wheel to remove. Fig. 7
Hex nut with washer on the motor shaft and take off the diamond wheel. Fig. 8
Pay attention to the direction of rotation When placing the diamond blade.
the separating plate With washer and 6-point nut. Fig. 10
Refit the splash guard to the eyes. Fig. 11
12.2
Mounting the saw blade cover
Mount the bracket using the supplied screws. Fig. 12
Set up in-line with the cutting disc when deviating the receiving plate this.
Fit the blade guard to the mounting plate with the locking screw and the 6-point nut. Fig.13
Make sure that the blade guard does not touch the blade.
13
OPERATION
13.1
Operating instructions:
Put the tile cutter securely on the ground. The cutting blade must not be with the ground or
other objects in conjunction.
Check each time before the blade is in good condition and securely attached
Fill the water reservoir up to the mark with water. Fig. 5
13.2
Operation:
13.2.1 Motor start / stopp
Switch ON
Check that the blade runs freely.
Ensure that the work surface is free of tools and objects.
Turn on the machine by pressing one of the green ON button.
Switch OFF
Run the material from the blade.
Turn on the machine by pressing from the red OFF button.
13.2.2 Notes:
Cut only as fast as it allows the material. If the speed of the cutting wheel in the feed greatly
reduced, slow down the feed!
No lateral pressure on the blade.
No operation without mounted blade guard!
Do not force. Material in the blade Let's eat the material into the blade.
No Dry cutting saw blades are suitable for wet cutting.
No curves intersect.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-FS115
ASSEMBLY
ON
OFF
16
Werbung
Inhaltsverzeichnis
Fehlerbehebung
