Residual Risks - Black & Decker MT18SS Handbuch

ENGLISH
Never allow children to use the tool.
u
Be aware of falling debris when cutting the higher slides of
u
@ a hedge.
Warning! Additional safety warnings
for shears
Never allow people unfamiliar with these instructions or
u
children to use the machine. Local regulations can restrict
the age of the operator.
Keep in mind that the operator or user is responsible for
u
accidents or hazards occurring to other people or their
property.
Never operate the machine while people, especially
u
children, or pets are nearby.
Use the machine only in daylight or good artificial light.
u
Take care against injury to feet and hands from the cutting
u
means. Only switch on the motor only when the hands
and feet are away from the cutting means.
Always ensure that the ventilation openings are kept clear
u
of debris.
Use only the manufacturer's recommended replacement
u
parts and accessories.
Inspect and maintain the machine regularly. Have the
u
machine repaired only by an authorised repairer.
@
Warning! Contact with, or inhalation
of dusts arising from cutting applica-
tions may endanger the health of the
operator and possible bystanders.
Wear a dust mask specifically
designed for protection against dust
and fumes and ensure that persons
within or entering the work area are
also protected.
Safety of others
This appliance is not intended for use by persons (includ-
u
ing children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concern-
ing use of the appliance by a person responsible for their
safety.
Children should be supervised to ensure that they do not
u
play with the appliance.
6
(Original instructions)

Residual risks.

Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving parts.
u
Injuries caused when changing any parts, blades or ac-
u
cessories.
Injuries caused by prolonged use of a tool. When using
u
any tool for prolonged periods ensure you take regular
breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed when
u
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
:
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
O
Wear safety glasses or goggles
when operating this tool.