Running Water; Attaching The Filter Pump; Pool Ladder; Tarpulin - wehncke Family Pool Venice 12293 Bedienungsanleitung

PoolBuch.book Seite 16 Mittwoch, 28. Januar 2009 7:15 19

5.2 Running Water

1. Close the inlet and outlet openings for the filter
pump and the discharge opening on the bottom of
the pool.
2. Fill the pool liner with ca. 2 - 3 cm of water.
3. Smooth out any possible wrinkles and wrinkled
surfaces on the floor. Climb directly into the pool
and carefully sweep along the edge of the floor with
your feet by going around the pool circumference
once. Make sure to not press too hard or to hit one
of the metal supports with your foot.
4. After you have smoothed out all of the wrinkles on
the floor, continue filling the pool liner with water
until the water level is ca. 3 cm above the top edge
of the upper hose attachment; a sufficient level is at
highest at the marking on the inside.
ATTENTION: Regularly check if the pool is equally
filled. If this is not the case (water collects in one spot
or the water surface slants to one side), immediately
shut off the water. This is a sign that the ground is not

5.3 Attaching the Filter Pump

After the pool is filled with water, attach the filter pump.

5.4 Pool Ladder

Entering and leaving the pool must be take place via
the pool ladder.

5.5 Tarpulin

When not in use, the pool should always be covered
with the supplied tarpulin for protection against
pollution.
• You connect the tarpulin to the pool with the zipper.
ATTENTION: The closure serves only for securing the
tarpulin. It does not offer sufficient protection against
unauthorized use of the pool.
16 English
level enough or that wrinkles in the liner bottom were
not smoothed out carefully enough. In this case, empty
the pool again completely and remove the wrinkles or
carry the pool to an appropriate spot.
NOTE: Regularly check the water level. The water level
must be 2-3 cm above the top edge of the upper hose
attachment (uppermost opening in the pool).
After Filling
• The outer walls of your pool could be wet.
Particularly in cooler areas, this process of
condensation is completely normal for this type of
pool and does not represent a sign of leakage. If
sweating on the outside of the pool foil occurs, this
usually stops 72 hours after filling the pool.
• Make sure that the water level does not get too high
(e.g. from rain water). With a water level that is too
high, promptly remove the excess water - in any
case before the next use.
To do so, observe the instruction manual for the
filter pump.
Observe the assembly instructions for the pool
ladder.
Children must be furthermore supervised in order
to prevent accidents.
• To secure the tarpulin, you
can close it with a commer-
cially available closure.