B2B BPM-1 Bedienungsanleitung Seite 18

3. Press and hold the SET button
Bluetooth® symbol will blink on the display of the blood
pressure monitor and a connection to the app will be established
(see fig. A and B).
4. As soon as a connection has been established, the Bluetooth®
symbol will stop blinking and all measurements will automatically
be transferred to the app.
5. Once the transfer is successful, the Bluetooth® symbol on the
display will go out. The device will switch to sleep mode. If it is not
possible to perform a transfer, the display will show the
Bluetooth® symbol and the error code "E7" (see chapter
"Troubleshooting").
Viewing the measurements on the measurement computer
You can also view the measurements you saved directly on the
measurement computer without a smartphone or tablet. Proceed as
follows to do so:
1. Activate the user touch buttons on the measurement computer
with the ON/OFF switch
2. Switch to memory mode by touching user 1 touch button
user 2 touch button
lights up with the average value for all measurements (see fig. A).
3. You can now browse through the measurements of the respective
user with the user 1 touch button or user 2 touch button (see
fig. A). Tap the respective button once to browse further.
The data will be displayed in this order:
• Average values for all measurements
for three seconds. The
(see fig. A).
for approx. three seconds until the LED
34
• Average values for the last seven measurements from 05:00
a.m. to 09:00 a.m.
Average values for the last seven measurements from 06:00
•
p.m. to 08:00 p.m.
60th measurement (last) up to the 1st measurement (oldest)
•
4. To view the values of the other user, touch the respective user
button.
5. After viewing all measurements, the measurement computer will
automatically switch to sleep mode. If you would like to leave
memory mode before this time, touch the user 1 or user 2 touch
button for three seconds.
Erasing measurements
You can completely erase the measurements of a user. Proceed as
follows to do so:
1. Activate the user buttons on the measurement computer with the
ON/OFF switch
2. Switch to memory mode by touching the user 1 button
2 button
average for all measurements.
or
3. Touch the user button of the user whose values you would like to
erase.
4. Touch both the user 1 button and the user 2 button at the same
time for 3 seconds. "CL --" and then "CL 00" will appear on the
display
All measurements of the respective user are erased.
5. You can now switch the measurement computer to sleep mode by
touching the user 1 or user 2 touch button for three seconds.
(see fig. A).
for three seconds until the LED lights up with the
(see fig. A).
35
or user