Initial Setup - Lancom Systems vRouter Installationsanleitung

LANCOM vRouter Installation Guide – Initial Setup

Initial Setup

A LANCOM vRouter can be configured via the local area network (LAN).
Make sure that the computer you are using for the configuration is on the
same LAN as the vRouter. If a DHCP server is active on the same LAN, the
vRouter is automatically given an IP address where it can be reached (and
found in LANconfig). If the vRouter was installed with an IP address, this
can be used to access the device. After the initial setup, the vRouter can be
integrated into the LANCOM Management Cloud.
The following configuration options for the initial setup are available:
A LANconfig
A WEBconfig
Configuration with LANconfig
LANconfig is a part of LANtools, the free LANCOM solution package.
LANconfig has a wide range of applications, from the user-friendly commis-
sioning of a single device with various Installation Wizards, to the holistic
management of several devices. It is available on the LANCOM website
free of charge.
Basic settings
After starting, LANconfig automatically searches the local network for new
devices and adds them to the overview.
In the overview, you invoke a context menu for the device with a simple
right-click of the mouse. This menu provides the options to Configure the
device or to start a Setup Wizard.
Run the Setup Wizard. If the device has not yet been configured (e.g.
during deployment on the ESXi server), a basic setup wizard starts
30