Troubleshooting Problems With The Sonorohifi - Sonoro SO-510 Bedienungsanleitung

8

Troubleshooting problems with the sonoroHIFI

Malfunctions can occur with any electrical equipment. This is not necessarily due to a device defect. As such,
you should check the following table to see if you can eliminate the problem yourself.
Malfunction
Device does not turn on
Device not responding
No sound
CD playback does not start
No Bluetooth connection, or Blue-
tooth connection interrupted
© sonoro audio GmbH 2016
Possible cause
Power cable is not properly con-
nected
Error in the device
Headphones are connected
Volume is set to minimum
Sound is turned off
Device not set to correct mode
Incompatible CD format
CD is dirty
CD is damaged
CD is upside down in the CD slot
The CD is not an original
Malfunctions due to other radio
transmitters or devices
Software on external Bluetooth
device not up to date
Solution
Connect the power cable properly.
Ä „Connecting the power
supply" on page 82
Switch the device off and on again.
Ä „Switching the device on and
off" on page 88
If the problem persists, please con-
tact sonoro audio GmbH customer
support.
Ä „Contact data" on page 63
Disconnect the headphone jack
from the port on the front of the
device.
Increase the volume.
Ä „Adjusting the
volume" on page 93
Switch on the sound.
Ä „Muting the audio play‐
back" on page 102
Select another audio source.
Ä „Selecting an audio
source" on page 94
Insert a different CD.
Clean the CD.
Insert a different CD.
Eject the CD and insert it correctly
into the CD slot.
Insert the original CD or a different
CD.
Increase the distance between the
sonoroHIFI and the source of the
interference.
Make sure that your external Blue-
tooth device has the latest software
version installed. Contact the man-
ufacturer of your external Blue-
tooth device to establish what soft-
ware versions are available.
109