Audio Setup; Dolby Digital Setup - AEG DVD 4626 iP Bedienungsanleitung

ENGLISH
60

Audio Setup

Dolby Digital Setup

Speaker Setup
Downmix
Change the characteristics of the speaker output:
K
LT/RT:
Choose this setting if you want to play the DVD with the Pro
Logic Dolby stereo effect. This produces a almost real 2-channel replay
effect.
K
Stereo:
Choose this setting if you want to play a DVD, that has been
produced in the 5.1-Audio format, as 2-channel stereo sound.
SPDIF Setup
SPDIF Output
Here you specify the settings for the digital Audio output.
K
SPDIF/Off: Output of an analogue Audio signal, but no digital signal.
K
SPDIF/RAW:
Output of a digital Audio signal. Use this setting if your
amplifier is no two-channel stereo amplifier.
K
SPDIF/PCM: Output of a digital Audio signal that is converted to a
2-channel signal. Use this setting if your amplifier is a two-channel
stereo amplifier.
NOTE:
If there is no Audio output, even though you connected the DVD-
Player to an amplifier, you will most likely have chosen an incorrect
setting for the Audio output.
LPCM Output
Here you can set the sampling rate of the audio signal. Generally speak-
ing, a higher sampling frequency produces a better audio signal.
Dual Mono
The Audio output is normally in stereo. Here you have the possibility to
choose Mono-output instead of Stereo-output.
K
Stereo: The Audio output is in Stereo (default).
K
L-Mono:
The Audio output is in Mono. In this case the signal of the
"left" stereo channel is transmitted to all speakers
K
R-Mono: The Audio output is in Mono. In this case the signal of the
"right" stereo channel is transmitted to all speakers.
K
Mix Mono: The Audio output is in Mono. In this case the signal of the
"both" stereo channel is transmitted to all speakers.