Hilti DX 76-PTR Bedienungsanleitung Seite 27

2.5 Contact pressure safety device
The tool can be fired only when pressed fully against a firm surface with a force of at least 50 N.
2.6 Unintentional firing safety device
The tool is also equipped with an unintentional firing safety device. This prevents the tool from firing if the trigger is first
pulled and the tool then pressed against the work surface. The tool can be fired only when it is first pressed correctly
against the work surface and the trigger subsequently pulled.
en
2.7 DX 76 PTR tool: applications and suitable fasteners
Fastening profile metal sheet to steel, steel thickness 6 mm – solid steel
Items required
Fasteners
Fastener magazine
Piston set
Items required
Fasteners
Single fastener guide
Fastening profile metal sheet to steel, steel thickness 3‑6 mm
Items required
Fasteners
Fastener magazine
Piston set
Items required
Fasteners
Single fastener guide
Fastening shear connectors
Items required
Fasteners
Shear connector
Fastener guide
Piston
Fastening profile metal sheeting to concrete (DX-Kwik)
Items required
Fasteners
Fastener guide
Piston
Stop drill bit
20
Ordering designation
X‑ENP‑19 L15 MX
MX 76‑PTR
X‑76‑P‑ENP‑PTR
Ordering designation
X‑ENP‑19 L15
X‑76‑F‑15‑PTR
Ordering designation
X‑ENP2K‑20 L15 MX
MX 76‑PTR
X‑76‑P‑ENP2K‑PTR
Ordering designation
ENP2K‑20 L15
X‑76‑F‑15‑PTR
Ordering designation
X‑ENP‑21 HVB
X‑HVB 50/ 80/ 95/ 110/ 125/
140
X‑76‑F‑HVB‑PTR
X‑76‑P‑HVB‑PTR
Ordering designation
NPH2‑42 L15
X‑76‑F‑Kwik‑PTR
X‑76‑P‑Kwik‑PTR
TX‑C 5/23
Comments
10 fasteners per magazine
strip
Comments
Single fastener
Comments
10 fasteners per magazine
strip
Comments
Single fastener
Comments
2 fasteners per shear con-
nector
Comments
Stop drill bit for predrilling