Cobra Spyball 6808-9 Bedienungsanleitung Seite 39

transmitter.
The alarm/immobiliser is disarmed, but
the motorcycle will not not start
(6828-9)
The system is not triggered by
moving/lifting the bike
___________________________________________________________________________________________________
SPYBALL 6808-9/6828-9 ENGLISH
paragraph 15)
Operate the transmitter closer to the unit (the area might be
-
affected by noises interfering with the radio signal)
- Replace the transmitter battery
- Realign the transmitters (see paragraph 2.1. )
- If none of these operations is successful, contact a Spyball
dealer (in the meantime, if the system is armed, disarm it with
the PIN code (see paragraph 16)
Make sure the motorcycle is in neutral gear
-
Make sure the kill switch is in the RUN position
-
- Make sure the main ignition fuse in the motorcycle is intact
- Make sure the motorcycle battery is charged
- Some models will only start with the side stand up or the clutch
lever pulled in – please check
If none of these operations is successful, contact a Spyball
-
dealer
- Has the inhibition time elapsed?
- Is the movement detector activated (not deselected)?
- If necessary, please adjust the movement detector (see
paragraph 7.)
If none of these operations is successful, contact a Spyball
-
dealer
39