Realignment Of A Transmitter; Pairing Of New Transmitters - Cobra Spyball 6808-9 Bedienungsanleitung

points. Do not delay the replacement of the battery, especially if you are using the Biker Recognition function,
because the system activates automatically when it does not receive any signals from the transmitter!
Remark: to ensure good contact, take the new battery out of its package and place it into the transmitter
without touching it directly with your fingers (use a soft cloth to manipulate it).

2.1. Realignment of a transmitter

The transmitters that come with the kit are paired originally, therefore they are already operating. Realignment
is needed when a paired transmitter gets desynchronised from the receiver.
This can happen if e.g. the transmitter is operated repeatedly outside the range of the receiver, because the
transmitted code is incremental, that is it changes every time the alarm is turned on/off thanks to an advanced
method of random encryption (anti-scanning / anti-grabbing protection).
To realign, just press and hold down push-button n. 1 of the transmitter for at least 7 seconds. A sequence of
flashes of the turn indicators will confirm the success of realignment. If the system is armed, it wil disarm.

2.2. Pairing of new transmitters

In the event of loss of failure, one or two new transmitters can be paired as follows:
If the security system is armed, disarm it with the remaining transmitter (if it is available) or enter your
emergency disarming PIN code (see procedure in paragraph 16).
Turn ignition on and wait 20 seconds.  The dashboard LED illuminates and remains on about 3
seconds.
Before the dashboard LED extinguishes, turn ignition off and then on again.  A short and sharp sound
signal confirms that the system is ready for pairing. The LED switches off. You have 6 seconds at your
disposal to complete the operation as described below.
___________________________________________________________________________________________________
SPYBALL 6808-9/6828-9 ENGLISH 23