Changing The Pin Code; Troubleshooting Guide - Cobra Spyball 6808-9 Bedienungsanleitung

16.2.

Changing the PIN code

If you wish, you can replace the original PIN code by a new one. The procedure is described below:
While the system is disarmed, turn the ignition on then press and hold down push-button n. 1 of the
transmitter about 7 seconds.  The LED illuminates about 3 seconds.
During this lapse of 3 seconds, press push-button n. 2.  A short sharp audible signal confirms you
have entered the procedure. The LED extinguishes, then it starts to flash slowly.
Count the flashes. As soon as you reach the number you have chosen as the first number of your
PIN code, turn ignition off.
Turn ignition on again and follow the same procedure to select the 3 remaining numbers.  A short
sharp audible signal will confirm that the procedure has been completed successfully.
Read the code you have entered (see paragraph 16.1.) to make sure it is correct, then record it.
Remark 1): You can select figures between 1 and 18. Once the LED has flashed 18 times, the procedure
stops and needs to be repeated:
Remark 2): To quit the procedure without making any changes, turn ignition off before the new code is
completed.

17. TROUBLESHOOTING GUIDE

Malfunction
The alarm does not respond to the
___________________________________________________________________________________________________
SPYBALL 6808-9/6828-9 ENGLISH
Recommended inspections / operations
Make sure the system has not entered the sleep condition (see
-
38