Reading The Pin Code - Cobra Spyball 6808-9 Bedienungsanleitung

Wait.  The alarm stops. The LED switches off, then it starts to flash slowly.
2.
3. Count the number of flashes. As soon as the number of flashes equals the first number of your PIN code,
turn ignition off (for example, if the first number of your code is 3, then wait for the LED to flash 3 times
before turning the ignition OFF).  The LED switches off.
4. Within three seconds, turn ignition on again. Count the number of flashes. As soon as the number of
flashes equals the second number of your PIN code, turn ignition off (for example, if the second number
of your code is 10, then wait for the LED to flash ten times before turning the ignition OFF).  The LED
switches off.
Enter the remaining numbers of the PIN code using the same procedure.  In the event of a mistake, an
5.
alarm cycle will follow. At the end of the alarm cycle it will be possible to restart the procedure.
ONCE ALL THE DIGITS HAVE BEEN ENTERED CORRECTLY, THE SYSTEM DISARMS WITH A LONG
BLEEP FOLLOWED BY FOUR SHORTER AUDIBLE SIGNALS, THEN IT SWITCHES TO SERVICE MODE
(see paragraph 12).

16.1. Reading the PIN code

If you have lost the PIN code but you have a working transmitter, you can recover the code with this simple
procedure:
While the system is disarmed, turn ignition on then press and hold down push-button n. 1 of the
transmitter about 7 secs.  The LED illuminates about 3 seconds, then it switches off for a short
time and subsequently it displays 4 strings of flashes.
Count and note the number of flashes in each string. Those are the numbers of the PIN code.
The end of the reading is confirmed by a short sharp audible signal.
___________________________________________________________________________________________________
SPYBALL 6808-9/6828-9 ENGLISH 37