Selection Of The Biker Recognition Function; Arming / Disarming Of The Security System; Arming / Disarming Without Biker Recognition Function (Use As A Conventional Transmitter) - Cobra Spyball 6808-9 Bedienungsanleitung

3.1. Selection of the Biker Recognition function

This selection shall be made on both the control unit and the transmitter.
For the setting of the control unit, please refer to the chart included in paragraph 14, which provides general
information about the possible configurations of the system (5 selectable functions).
Additionally, the Biker Recognition function shall be activated/deactivated from the transmitter:
To activate, press and hold down both push-buttons at the same time until the small LED located on the
transmitter starts to flash quickly for about 2 seconds. (*)
To deactivate, press and hold down both push-buttons until you get a long flash from the LED (*).
If you expect to leave this function unused for a long time, it is recommended to deactivate it at least from the
transmitter, because this reduces the current consumption rate conspicuously and makes the battery life
longer.
(*): to avoid accidental arming or activation of the panic function (which may occur if the two buttons are not
pressed exactly at the same time), carry out this operation at a distance from the motorcycle, outside the
range of the receiver.

ARMING / DISARMING OF THE SECURITY SYSTEM

4.
4.1. Arming / disarming without Biker Recognition function (use as a conventional
transmitter)
To activate the system, press push-button n. 1 of the transmitter once.
Arming is confirmed by:
Three short flashes of the turn indicators.
___________________________________________________________________________________________________
SPYBALL 6808-9/6828-9 ENGLISH 25