Mounting Instructions - Klauke HK 5/22 Bedienungsanleitung

Instruction manual HK 5/22
___________________________________________________________________________

5.3. Mounting instructions

If other applications that exceeds those mentioned in table 2&3 must be performed with this
tool it is necessary to contact the manufacturer.
Table 3 Marking of the dies
relation Dies
Tab. 2
a „Standard type"
b DIN 46235/
DIN 46267
c Aluminium
d Compression joint
Aldrey
e Compression joint
DIN 48085 part 3
f Pre-rounding dies
g Terminals
DIN 46234/46230
Instruction manual HK 5/22
___________________________________________________________________________
5.3. Mounting instructions
If other applications that exceeds those mentioned in table 2&3 must be performed with this
tool it is necessary to contact the manufacturer.
Table 3 Marking of the dies
relation Dies
Tab. 2
a „Standard type"
b DIN 46235/
DIN 46267
c Aluminium
d Compression joint
Aldrey
e Compression joint
DIN 48085 part 3
f Pre-rounding dies
g Terminals
DIN 46234/46230
Marking
outside crimping profile
CU, „QS" „QS"
CU, „QS", code number
DIN 46235
AL, „QS" code number
Al, „QS" code number
Al, „QS" code number
ST, „QS" code number
RU; QS, sm; -
QS, sm
CU, „QS", QS
DIN 46234
Marking
outside crimping profile
CU, „QS" „QS"
CU, „QS", code number
DIN 46235
AL, „QS" code number
Al, „QS" code number
Al, „QS" code number
ST, „QS" code number
RU; QS, sm; -
QS, sm
CU, „QS", QS
DIN 46234
page 34
surface of the dies crimping
width
chrome plated, 5 mm
yellow
chrome plated, 5 mm
yellow
blue zinc 7 mm
blue zinc 7 mm
blue zinc 7 mm
black 5 mm
chrome plated, -
yellow
chrome plated, -
yellow
page 34
surface of the dies crimping
width
chrome plated, 5 mm
yellow
chrome plated, 5 mm
yellow
blue zinc 7 mm
blue zinc 7 mm
blue zinc 7 mm
black 5 mm
chrome plated, -
yellow
chrome plated, -
yellow